Publicidad
Idiomas disponibles
Idiomas disponibles
6. Installation
6.1.
General Installation Instructions
During the entire process of installation, the device must not be connected to the electrical
mains.
The pump and the entire port system must be protected against frost.
All connection lines have to be perfectly tight since leaking lines may affect the performance of the pump and
cause considerable damage. If required, please use a suitable sealant to make the installation airtight.
Avoid when tightening screw excessive force that may cause damage.
When laying the connection pipes, you should make sure that the pump is not exposed to any form of weight, vi-
bration or tension. Moreover, the connection lines must not contain any kinks or an adverse slope.
Please observe the illustrations, too, which are contained as an attachment at the end of the present operating in-
structions. The numeric and other details included in brackets below refer to these illustrations.
Please observe the graphic figures in this manual. The numbers and other indications in brackets refer to the fol-
lowing graphic figures in this text.
6.2.
Installation of the pool filter system
Mount the pump on the plate provided by pulling it along the dotted line so that the pump snaps into place. Insert
the seals into the connection pieces and screw them onto the pump openings.
Install the drain plug. Screw the internal filter together in the direction of the arrow as shown. Then assemble the
outer connection piece and the internal filter and finally install them with the tank.
Translation of original operating instructions
3
Publicidad
