CleanSpace HALO Guia De Inicio Rapido página 5

English
CleanSpace Respirator Quick Start Guide
Please read the entire CleanSpace Respirator Quick Start Guide before using a CleanSpace Respirator.To view additional
instructions and product information, go to
relevant national standards in each local region and review methods to determine that a satisfactory fit test of your
CleanSpace Respirator has been achieved.
1. Warnings & Limitations
CleanSpace is a powered air purifying respirator (PAPR) and should be used with the battery charged and in Power-On mode.
CleanSpace Respirators are intended to protect against substances and mixtures which are hazardous to health.
If your CleanSpace Respirator is intrinsically safe, it will be clearly marked as such. Do not use non-intrinsically safe
respirators in flammable or explosive atmospheres. Do not use in IDLH, or in oxygen enriched or deficient atmospheres.
Do not submerge the respirator in water. Do not use compressed air or a brush to clean the filter.
Operating Conditions: 0% - 90% RH, -10°C to 45°C. Storage Conditions: 0% - 75% RH, 10°C to 30°C.
Manufacturers Minimum Design Condition/Duration: CleanSpace Respirators will maintain positive pressure in the mask up
to 120 l/min. Minimum 4-hour duration. The user must do a Flow Test to check the design condition before each use.
During pre-use visual inspection, if parts are missing or damaged replace them with approved parts before proceeding.
European users should be aware that all markings on the filter refer to the standard EN 12942 (1998) + A2 (2008).
2. System Description
2.1. ALARMS
A.
Filter Change Alert Two (2) beeps, Filter Alarm Light will flash. Change filter before entering the contaminated area.
B.
Low Battery Alarm Three (3) beeps. Less than 15 minutes runtime. Leave the contaminated area immediately.
C.
Filter Absent Alarm (CST1002 & CST1012) – Constant beep, Filter Alarm Light will flash. Install filter before entering
the contaminated area.
2.2. BATTERY, FILTERS & PRE-USE PROCESS
Charge Battery
3. Donning the CleanSpace PAPR
Assemble
Assemble
4. Care and Cleaning
Cleaning or disinfectant wipes can be used to wipe down the components. Use a clean cloth to remove any cleaning
residue before use. The mask, harness and neck support can be washed with a mild detergent in warm water. Power units
mustnot be submerged in water. CleanSpace filters cannot be cleaned. Unopened filters have a storage life of five (5)
years.
S008-7015 - Instructions - English - Rev 7 ECN2227
cleanspacetechnology.com/product-resources/
Replace Filter
Turn On
Turn On
Visually Inspect all
Recalibrate Unit
Parts Before Use
Don
Don
. Before use, refer to the
Flow Test: Battery &
Filter Lights Flash = FAIL
Adjust
Adjust