Publicidad
Idiomas disponibles
Idiomas disponibles
Problems
The soleplate is dirty or
brown and may stain
the linen.
There is no steam or
there is little steam.
steam comes out from
around the collector.
The red "water tank
empty" light flashes.
Steam or water escapes
under the appliance.
The orange"Calc Away
OK button" light is
lighting
Possible Causes Solutions
You are ironing at too high
a temperature.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
You are using starch.
The water tank is empty
(red light flashing).
The soleplate temperature
is set to the maximum.
The water tank is not
correctly fitted into its
housing.
collector is not tight
enough.
The seal of the collector is
damaged.
The station is faulty.
You did not press the
"OK" button.
The station is faulty.
You did not press the
"OK" button.
See our recommendations regarding
temperature control setting.
Ensure linen is rinsed thoroughly to remove
any soap deposits or chemicals on new
garments which may be sucked up by the
iron.
Aways spray starch on the reverse side of
the fabric to be ironed.
Fill the water tank and press the "OK"
button on the control panel.
The station is working but steam is very hot
and dry. As a result, it is less visible.
Push it into position until it «clicks» into
place.
Tighten the collector after having let the
appliance cool for 2 hours.
Contact an Approved Service Centre.
Stop using the station and contact an
Approved Service Centre.
Press the "OK" button on the control panel
until the indicator goes out.
Stop using the station and contact an
Approved Service Centre.
Press the "OK" button on the control panel
until the indicator goes out.
14
Publicidad
