GBC HeatSeal Sprint H925 Manual De Instrucciones página 4

HeatSeal Sprint H925 - Operation
®
For optimal laminator performance, see "Tips" page 15.
STEP 1
Side
Adjust side
Guides
guides and place
document(s) in
feeder.
STEP 2
(Power LED)
Press start and
lamination will
begin after warm
Start Stop
up. (See page 13
for additional
information).
3 mil / 75 mic 5 mil / 125 mic
STEP 3
(Ready LED)
Ready LED
will flash during
process warmup.
Start Stop
At the beginning
of each job, first
output will be film
3 mil / 75 mic 5 mil / 125 mic
only as film aligns to
edge of document.
*First output will be film only as film aligns to leading edge of document.
6
TM
Start Stop
3 mil / 75 mic 5 mil / 125 mic
HeatSeal Sprint H925 - Load Film
If possible, always load film before running completely out.
STEP 4
Machine ready,
lamination in
process.
STEP 5
Laminated
document(s) will
stack in exit tray.
Lamination will
stop when job is
complete*.
Heat
Button
® TM
STEP 1
Cut laminating
film as indicated
in diagram at left.
If film is not
present see next
page.
STEP 2
Open all 4 EZload
levers and
remove film.
STEP 3
Remove idler bar
assembly, then
Start
press "Heat"
button. Ready
LED will flash
3 mil / 75 mic
during warmup.
(Film Select)
STEP 4
Insert new film,
overlap film on
heat shoe.
Note: Match colors
of film core ends to
EZload levers.
STEP 5
Insert and lock
idler bar assembly,
then close 4
EZload levers.
STEP 6
Press feed switch
(forward) and
hold until
wrinkle-free
lamination.
Close top.
STEP 7
Select film
thickness.
Stop
5 mil / 125 mic
7