Cutting Height Adjustment - TRAPP MC-850G Manual De Instrucciones

www.trapp.com.br
Models MC-80G, MC-90G, MC-500G,
MC-550G, MC-600G, MC-650G,
RS-40G
The cutting height is adjusted as follows:
Bend the adjustment rod in the direction
 
of the wheel (1) to unlock it. After that,
move it either to the right or to the left (2),
according to the height you wish.
There are 5 positions to mow the grass at
 
the desired height and for the grass mower
to move freely.
1
Model MC-850G, CG-40G
To adjust cutting height pull axle toward you
and set to desire cutting height see figure
below:
Grass cutting height
1. Higher
2. Medium
3. Lower

Cutting Height Adjustment

2
3
2
1
Warning!
When adjusting the cutting height, turn off
the motor and check whether the cutting
blade is still turning before carrying out the
adjustment.
To avoid engine overload, select the cutter
 
edge height according to yard condition.
For the types of grass used in Brazil, it is
 
recommended to keep them 2 and 3 cm
high from soil. If lawn is excessively high,
perform 2 or more cutting with different
height adjustments. This procedure will
help to improve equipment life.
According to cutter model (with or without
 
grass-holder, with side outlet), use a
cutting sense as shown in the illustrations
below.
Machines with grass-holder - Clockwise sense.
Machines with grass-holder and side outlet -
Anti-clockwise sense.
43