Publicidad
Idiomas disponibles
Idiomas disponibles
LOCKOUT
FEATURE
(TOUCH PAD MODELS)
Your ice and water dispensing
system can be locked out to
unwanted use.To do this, press the picture of the
_adiock for 3-5 seconds
When the system is locked off, a
_mall red light will appear over the padlock
To unlock the
system,
press the padlock
for 3-5 seconds
until the small
red light goes ouL Your ice and water dispenser
is now
ready to use again
1o ice cubes stored too long may develop an odd flavor:
Empty the container
and return it to the proper position.
The Ice Maker wilt then produce more ice°
2. Occasionally
shake the container to keep ice separated
& If the dispensing
arm is pushed in for more than 4
minutes, the dispenser
motor may overload and sto F
The overload protector
will reset automatically
after 3 or
4 minutes
If a large quantity of ice is needed at one
time, it is best to remove cubes directly from the ice
storage bin,,
4,, Certain sounds are normal when the Ice Maker is
operating. They are:
- Motor operation
• fce being loosened from the tray
• ice dropping from the storage bin
- Running water
- Water valve opening or' closing
For more information
on these operations,
see Normal
Operating Sounds
5o Stop the Ice Maker' when cleaning the freezer or for fong
vacations.
6, If the Ice Maker is to be turned off for a long period of
time, turn the water suppiy valve to the closed position,
CLEANING
THE ICE DISPENSER
Clean the dispenser and ice storage bin at regular intervals,
particularly
before you take a vacation or move, or if the Ice
Dispenser
sticks.
1, Stop ice production
by lifting the wire signal arm to the
"up" or OFF position,
2. Remove ice storage bin by lifting up and out Empty and
carefully clean the bin with mild detergent,. Do not
submerge
the bin while cleaning. Rinse with clear water,
Do not use harse or abrasive cleaner&
Allow ice bin to
dry completely
before replacing in the freeze_
3 Remove ice chips and clean the shelf and chute that
supports the ice storage bin°
4. Replace the ice storage bin Lower the wire signal arm
on the Ice Maker to the "down" position or ON position
and the Ice Maker will resume production.
IMPORTANT:
When removing or replacing the ice bin, do
not rotate the auger in the ice bin If the auger is
accidentia[ly turned, you must realign the auger by turning
[t in g0 ° turns unt[! the ice bin fits into place with the drive
mechanism,
For further instruction,
see the label on the ice
bucket.
Remove and empty the ice storage
bin if:
1, An extended power failure (one hour or longer) causes
ice cubes in the ice storage bin to mett and freeze
together and jam the dispenser
mechanism,.
2 The ice dispenser is not used frequentiy_ Ice cubes will
freeze together in the ice storage
bin and j'am the
dispenser mechanism.
Remove the ice storage bin and
shake to loosen the cubes
NEVER use an ice pick or similiar sharp instrument
to
break up the ice, This could damage the ice storage bin
and dispenser mechanism.
Do not use the
ice
chute as a handle
when removing
or
replacing
the
ice
storage
bin.
Surfaces
there may be sharp.
10
Publicidad
