Keep your refrigerator
and freezer clean to prevent odor
build-up, Wipe up any spitls immediately
and clean both
sections at least twice a year, Never use metallic
scouring pads, brushes, abrasive
cleaners
or strong
alkaline solutions
on any surface_ Do not wash any
removable
parts in a dishwasher_
Always
unplug
the power
cord from the wall outlet
before
cleaning.
NOTE: Turning the control to OFF does not disconnect power
to the controls, light butb. or other electrica! component&
Damp objects
stick to cold t
metal surfaces. Do not touch refrigerated I
surfaces with wet or damp hands,
INSIDE
Wash inside surfaces of the refrigerator
and freezer with a
solution
of 2 tablespoons
baking soda in 1 quart warm
water, Rinse and dry thoroughly Be sure to wring excess
water out of sponge
or cloth before
cleaning
around the
controls, light bulb, or any electrical
parts.
Wash removable
parts such as shelves and drawers with
baking soda solution or mild detergent
and warm water Do
not use harsh cleaners
on these surfaces_
Rinse and
dry thoroughly
Clean the door gaskets with mild suds,
rinse with clear water and wipe dry,
Do not use razor blades or other sharp instruments
which
can scratch the appliance surface when removing adhesive
labels Any glue left from the tape or energy label can be
removed with a mixture of warm water and mild detergent,
or. touch the glue with the sticky side of tape a#eady
removed. Do Not removethe
serial plate.
OUTSIDE
Wash the cabinet and handles with warm water and mild
liquid detergent,
Rinse well and wipe dry with a clean soft
cloth Do not use commercial
household
cleaners,
ammonia,
or alcohol to ctean handles,
Clean stainless steel (some models)
front and handles
with hot soapy water and a dishcIoth.
Rinse with clean
water and a soft cloth. Wipe stubborn
spots with an
ammonia-soaked
paper towel, and rinse_ Cleaners made
especially forr stainless steel, such as Sheila Shine,
trademark
of Sheila Shine, inc.
Stainless
Steet Magic,
trademark
of Magic American
Corp,, or similar products
are suggested
AIways follow manufacturer's
instructions.
Wash the rest of the cabinet with warm water and mild liquid
detergent, Rinse welt, and wipe dry with a clean soft cloth,
Remove any dust or dirt from the front of the toe grille using
a vacuum cleaner with its dusting toot attachment,
Remove
the toe grille by pulling it straight ouL While the grille is
removed,
vacuum the backside
of the grille and wipe with a
sudsy cloth or sponge.
12
To avoid damage and help
the refrigerator run as efficiently
as
possible, clean the condenser
and air
vents periodically
Periodically
clean the condenser
(black tubes and wires
beneath the refrigerator,
behind the toe grille), Do not allow
lint or dust to accumulate
on the coils insert a long handled
brush or vacuum attachment
between the two coils to bring
the tint forward To replace the toe grille, line up tabs with
holes and push grille straight on,
_
Use caution when
cleaning in the area of the coifs_
Surfaces there may be sharp
The air vents on the lower access panel at the rear of the
refrigerator
should be cleaned periodically. Clean the vents
by using a vacuum cleaner with its dusting toot attachmenL
When moving the refrigerator,
pull straight out, Do not shift
the refrigerator
from side to side as this may tear or gouge
the floor covering
Be careful not to move the refrigerator
beyond plumbing connections,
Vents
Air Vents on Lower Access Panels
REPLACING
THE
LIGHT
BULB
To replace
the light bulb in either compartment:
1 Unplug refrigerato_
2,, Wear gloves as protectio_
against possible broken glass,
3, Replace otd bulb with an appliance
bulb of the same
wattage
4, Remember
to plug refrigerator back in_
Ughl Shiefd
pTo
Remove
Removing Cdsper Ugh_ Shield end Bulb (some
models)