Sears Kenmore 25359682992 Manual Del Usuario página 9

Theiceandwater d ispenser onthefreezer door
convenientfy dispenses chilled water, and
either ice cubes
or crushed ice, depending on the model. Some models
feature a slide knob selector for ice and water dispensing,
while other models feature a touch pad selector lor
dispensing
To operate the dispenser, press the pad or slide the knob for
the selection of your choice and press a glass against the
dispensing arm Hold the glass as far up as possible to
catch all ice. To stop dispensing, pull glass away from
dispensing arm.. When dispensing ice, release the
dispensing arm before the glass is full, but do not remove
the glass until the ice has completely dispensed
(Complete instructions for the dispenser operation are
attached to the inside of the freezer door.)
A small heated area beneath the dispenser floor catches
and evaporates small spills, This drip tray is removable
and dishwasher safe, Do not pour water or excess
cubes into this area because there is no drain,
LIGHT
The dispenser has a light which can be turned on and off by
sliding the knob to the desired position or by pressing the
"Light ON/OFF" pad The light also turns on automatically
when ice and/or water is dispensed. Replace light bulb with
an appliance butb of the same wattage.
Dispenser Selector
Slide Knob
Touch Pad
HOWTHE WATER DISPENSER WORKS
The water tank is located behind the drawers inthe refrigerator
compartmept As the water is dispensed, the tank is
automatically refilled. For proper operation of the dispenser, the
supply water pressure musl fall between 30 psi and 120 psi.
After the refrigerator is installed and the plumbing
connections are complete, the water tank should be filled
by drawing one glass of water. This will take about 1-1/2
minutes. Then, draw and discard 7 more gfasses to be sure
that the tank and plumbing connections are rinsed of any
impurities.The water delivery system has a built in shut off
device thai will stop the water flow after 3 minutes of
continuous use Simply release the actuator button to reset
the dispensing mechanism.
To ensure fresh-tasting water, ptan to use the dispenser
every day If the water dispenser has not been used for a
week or more, draw and discard 7-8 glasses to freshen the
tank supply
HOW THE ICE DISPENSER WORKS
The ice maker and ice storage bin are located in the top left
corner of the freezer compartment After the refrigerator is
installed properly and has cooled for several hours, the ice
maker can begin making ice To begin ice production, lower
the wire signal arm to the "down" or QN position. As cubes
are made, they are stored in the storage bin. Although it
may take t or 2 days to fill the bin, the dispenser may be
used after the first batch o! ice is made. The ice maker
turns off automatically when the ice storage bin is full
Because of new plumbing connections, the first production
of ice cubes may be discolored or have an odd flavor..
These should be discarded until the cubes made are free
of discoloration and taste
[_Remember, water quality determines your ice
quality It is best to connect the ice maker to water that is
not softened Chemicals from a malfunctioning softener
can damage the ice maker. If ice maker is connected to
soft water, ensure the softener is maintained and working
properly.
Press glass against dispensing arm
Slide Knob Touch Pad
To stop the ice maker, lift the wire signal arm until it clicks
and locks in the "up" or OFF position
Ice Maker