cecotec Energysilence Aero 3600 Vision Full Black Manual De Instrucciones página 38

ENGLISH
cools down. (Be careful, the bulbs can reach very high temperatures during use).
- Remove the bulb by holding it firmly and turning it counterclockwise. To do this, hold it
firmly and turn it counterclockwise.
- Take a new bulb and put it carefully into the lamp holder. Screw it clockwise.
- Turn the power supply on again and switch the lamp on.
Important
This fan uses 1 E27 / Max bulb. 60 W (not included)
Cleaning
- Unplug the fan and allow it to cool down before cleaning it.
- Never immerse the fan in water or other liquids.
- Clean with a soft, dry cloth.
- Do not use any cleaning chemicals such as detergents and abrasives.
- Do not allow water to come into contact with any of the electrical parts of the appliance.
- Do not use a wet cloth to clean the motor. Keep the fan clean and store it in a dry place to
avoid moisture if you're not going to use it for some time.
- We recommend using neutral detergent and a soft cloth. Do not use solvents, acid
detergents, petrol, alcohol, etc. to clean the plastic parts, as they may be damaged.
- Do not allow water to enter the motor or touch the cable during cleaning.
6. TROUBLESHOOTING
If the fan does not turn on:
- Check the fuses or circuit breakers at the electric panel.
- Check the fan cables.
- Warning: make sure the main supply is off
- Make sure that the commutator is firmly in position. The fan will not work if the switch is
in the middle position.
- If the fan does not work, please contact the official Cecotec Technical Support Service. Do
not try to repair the internal electric connections.
If the fan makes a lot of noise:
- Check that all screws on the motor housing are properly fixed (do not overtighten them).
- Check that the screws fixing the blade bracket are tight enough.
- Allow the fan to run for 24 hours. Most of the noises produced by the fan will disappear
after this time.
38 ENERGYSILENCE AERO 3600 VISION FULL BLACK | WHITE | PINK | YELLOW | GREEN | BLUE