Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 13:
(SEE FIGURE 13)
*
Fasten the hopper braces (11) to the hopper support
tubes using the nylock nuts (J) that were assembled
earlier. Do not tighten completely.
*
Fasten the loose ends of the hopper braces to the
hitch tube using a 1/4" x 2" hex bolt (C) and a 1/4"
nylock nut (J). Do not tighten completely.
11
!
c
FIGURE 13
STEP 14:
•
Tighten all bolts and nuts except for those shown in
step 10 that fasten the control bracket to the hitch tube.
STEP 15:
(SEE FIGURE 14)
•
Slide a 5/8" washer (O), a spacer (L), a 5/8" washer
(O) and a wheel onto the end of the axle with no hole.
•
Carefully hammer a hub cap (Z) onto the axle.
o
L
O
STEP 16:
(SEE FIGURE 15)
*
Slide a 5/8" washer (O), a spacer (L), a 5/8" washer
(O) and a wheel onto the end of the axle with a hole.
*
Attach the wheel to the axle with a 3/16" x 2" cotter
pin (R).
*
Carefully hammer a hub cap (Z) onto the axle.
FIGURE 15
STEP 17:
(SEE FIGURE 16)
•
Set the adjustable stop at "5" and move the control
hande back against it.
•
Slide the control bracket along the hitch tube until the
flow plate in the bottom of the hopper is open half way.
•
Tighten the bolts and nuts fastening the control
bracket. Do not deform the control bracket.
•
Make sure the flow plate will open and close all the
way. Readjust if necessary.
FIGURE 14
7
FIGURE 16
Publicidad
Tabla de contenido
