RODE NT-USB Guia De Inicio Rapido página 5

INDONESIAN
1. Letakkan cincin filter pop di sekitar dasar NT-USB
Anda.
2. Putar benang pada dasar NT-USB Anda ke dalam
pemasangan cincin hingga mikrofon dan filter
pop terpasang dengan aman.
3. Pasang tripod yang disertakan ke sisi lain
pemasangan cincin dan posisikan sehingga
mikrofon dapat duduk dengan stabil di meja
Anda.
4. Hubungkan kabel USB yang disertakan ke bagian
bawah NT-USB untuk menghubungkannya ke
komputer Anda.
5. Pastikan knob atas diatur setengah jalan, dan
knob bawah sepenuhnya berlawanan arah jarum
jam.
6. Sambungkan headphone ke output 3,5 mm
di bawah knob, lalu perlahan-lahan tingkatkan
knob bawah hingga Anda dapat dengan nyaman
mendengar suara Anda.
7. Sesuaikan knob atas untuk menyeimbangkan
volume suara Anda dan audio yang datang dari
komputer Anda.
NORTH AMERICA
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Please note that changes or modifications of this
product is not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna
-- Increase the separation between the
equipment and receiver
-- Connect the equipment into an outlet on a
circuit different from that to which the receiver is