Publicidad
Idiomas disponibles
Idiomas disponibles
BLENDER JAR ASSEMBLY
To use your Cuisinart
Glass Jar Blender, begin by assembling the
blender jar.
1. Remove blender jar lid. Turn the blender
jar (a) upside down and place it flat on a
sturdy surface.
Note: You may need to position the
rubber blade gasket (b) into the groove of the
blade assembly if not tightly in place.
2. Turn the blade assembly (c) upside down
and place the blade end in the blender jar
base opening.
3. Twist blade assembly (c) clockwise
until secure.
Note: Blades are sharp. Handle carefully.
c.
b.
a.
HELPFUL REMINDERS
•
Once the blender jar lid is in position,
additional ingredients can be added
during blending by simply removing the
measuring cup, adding ingredients, and
replacing the measuring cup.
•
Blender jar lid should always be in place
while the unit is on.
•
Warning: Do not remove or install blender
jar on base while motor is running.
•
Do not remove blade assembly from blender
jar when removing blender jar from base.
Simply lift blender jar from motor base.
•
Never put boiling liquids or solid frozen
foods (with the exception of ice cubes or
½-inch [1.3cm] pieces of frozen fruit) in the
blender jar.
•
Do not put ice, frozen foods, or cold liquids
into a blender jar that has come directly out
of a hot dishwasher.
Hurricane
48-oz.
®
®
•
Do not put very hot liquids or foods into a
blender jar that has come directly out of
the freezer.
•
Follow Cleaning and Maintenance instructions
on page 6 prior to your first use.
OPERATION
1.
Place the motor base of your Cuisinart
Hurricane
48-oz. Glass Jar Blender on a
®
flat, sturdy surface. It is important that
the surface be clean and dry. Assemble
the blender jar by following the Blender Jar
Assembly instructions.
2. Put all necessary ingredients into the blender
jar and replace the lid. You may add more
ingredients during operation by lifting the
removable measuring cup and dropping
ingredients through the fill area. Replace the
removable measuring cup after adding
ingredients. Do not put hands into blender
jar with blender plugged in.
Note: Add liquid ingredients first, then follow
with solid ingredients. This will provide more
consistent blending and prevent unnecessary
stress on the motor.
Note: To remove blender jar lid, lift edge of
lid upward. Turning and lifting removable
measuring cup will not remove blender jar lid.
3. Once the jar is assembled and is in
position on the motor base, plug the unit into
an electrical outlet. Solid Red LED indication
ring will be on when no jar is placed on the
motor base.
4. Start blending:
The white LED indication ring on the control
dial will start flashing, indicating the blender
is ready.
5. Choose blending action:
To set manual or preset mode: Turn the control
dial and select the desired preset program
- Manual, Smoothie, Ice Crush, Milkshake,
Cocktail (coarse, fine), Clean, Pulse.
Press the control dial to start the selected
program at the preset program. The LED
display will show a solid white ring. Note: At
the end of a program or in the auto-off timer,
the red LED indication ring will flash.
When the machine is operating in a preset
mode, a countdown timer will be displayed.
Manual mode: Turn the control dial to
Manual and press once to select. Rotate dial
to choose a desired speed: Low 2, 3, 4, or
High. Press the control dial one more time to
start blending.
5
®
Publicidad
