Anova TPB4503 Instrucciones página 69

5. INSTRUCTIONS FOR USE
5.1. Start up
1. Remove the machine from the packaging. Install the lithium battery, turn on the power
switch. You should hear two beeps; This means the battery is charged.
2. Press the trigger continuously and quickly twice to start the machine.
3. Progressive cutting: In the starting state, hold down the trigger and then press the
power switch at the same time for 10 seconds. Changed the progressive cut-off when
hearing the sound of two beeps.
4. Aperture size adjustment:
a. Progressive mode: The opening size can be controlled at will. Slowly press the
trigger and when the blade reaches the required opening size, hold the trigger
still and the specified opening size can be changed upon hearing the sound of
two beeps. Hold the trigger for 3 seconds and release to restore maximum
aperture.
b. Normal mode: In the boot state, press the power switch for 0.1 seconds and
release it. When you hear the sound of 2 beeps, pull the trigger and the opening
will complete the change of 2.5cm, 3.2cm and 4.5cm in one cycle.
5. Power off: Hold the trigger for 5 seconds, release the trigger when you hear the sound
of two beeps, blade will close automatically. The power will be turned off automatically
if the machine is not used for 10 minutes.
5.2. Use tips
After a long time of use, the machine's battery may increase in temperature, this is normal.
Add lubricating oil to the blade for proper maintenance. It is very important that you keep the
scissors in good cleaning and care conditions.
Prune at the furthest part of the shoot to avoid loss of sap to the plant.
Do not prune branches too far back on the tree, as this will reduce the health of
the plant. Leave a small section of the branch to avoid stressing the plant.
While working with the scissors, keep your hands away from the cutting blades
and wear gloves or other appropriate protective equipment.
Remove diseased shoots and remove dry branches on the plant.
When pruning a tree, prune each branch separately and do not cut multiple
branches at once.
5.3. Battery charge
The battery of the new product does not come fully charged. Before
charging, insert the battery into the charger and plug the charger into a
power outlet. The charger indicator light turns red, indicating that the
charger is charging; If the charger light is green, the battery is charged and ready to use.
8
EN