Anova TPB4503 Instrucciones página 71

4. Remove the screws (note: left side screws), as shown in fig. 4.
5. Replace the blade and grease the gear, as shown in fig. 5.
6. Install the blade and gear on the scissors, as shown in fig. 6.
7. Lock the screws (note: left side screws), as shown in fig. 7.
8. Install the plain bearings and locknuts, as shown in fig. 8.
9. Install the lock washer and lock the screws, install the top cover and lock the screws,
as shown in fig. 9.
Warning
The supporting blade and movable blade can be replaced independently; as a replacement,
don't worry about too small aperture of the blade; After recovering power to the scissors, the
normal opening size will automatically recover.
6.4. Scissor maintenance
1. Do not cut branches outside the cutting range; Do not cut non-plant materials, such as
metals and stones, etc. do not use clamps or similar to hold the scissors; Always
replace the cutting blade if it is worn or damaged.
2. Keep the cutting equipment clean, wipe the scissors, batteries and charger with a clean
cloth (do not use corrosive detergents) and a soft brush or dry cloth to clean the dust
on the upper scissors.
3. Do not immerse the scissors, batteries and charger in water or other liquids;
4. Use the equipment correctly; Stop using it when there is damage to the scissors,
batteries and/or chargers.
5. If the switch cannot turn the scissors on or off, please do not use the scissors. It will be
dangerous to control the scissors without the switch properly. Always replace and
repair the switch in this case before using the scissors again.
6. Make sure the switch keeps the shears off when replacing accessories or storing the
pruning shears. This preventive measure will reduce the risk of accidentally activating
the scissors and causing injury to the user.
10
EN