Anova TPB4503 Instrucciones página 73

7. WARRANTY
If your product suffers from a manufacturing defect during the established warranty period,
please contact or go to your point of sale directly with the necessary documentation.
Your purchase invoice should be kept as proof of the purchase date. Your tool must be
returned to your dealer in acceptable, clean condition, in its original molded case, if applicable
to the unit, accompanied by your applicable proof of purchase.
7.1. Warranty period
The legal warranty period of the product begins on the original date of purchase by the first
initial buyer and its duration will be that established by the Royal Decree-Law on the protection
of consumers and users against situations of social and economic vulnerability of the year.
corresponding to the time of purchase of the product.
Some countries do not allow limitations on how long an implied warranty lasts or do not allow
the exclusion or limitation of consequential or incidental damages, in which case the above
limitation and exclusion may not apply to you. This warranty gives you specific legal rights, and
you may also have other rights which vary from state to state or country to country.
7.2. Exclusions
This warranty does not cover product damage or performance problems caused by:
- Natural wear and tear.
- Misuse, neglect, careless operation or lack of maintenance.
- Defects caused by incorrect use, damage caused due to manipulations carried out by
personnel not authorized by Anova or use of non-original spare parts.
- Defects of normal wear parts, such as bearings, brushes, cables, plugs or accessories
such as drills, bits, saw blades, etc.
- Damage or defects resulting from abuse, accidents or alterations.
- Improper use and storage (explicit reference to the fact that the rules described in the
operating instructions have not been followed).
- Customer-caused wear (e.g. broken saw blades, worn carbon brushes, etc.).
- Secondary wear and damage due to lack of maintenance, repair, lubricants (e.g.
overheating damage due to blocked cooling slots, bearing damage as a result of dirt,
frost damage, etc.)
- Damage as an obvious result of excessive use/overload.
- Damage caused by improper supplies (e.g. incorrect fuel)
- Load-induced failure of casing components or accessories due to abnormal stress
- Load-induced deformation of casing components or accessories due to abnormal
stress.
- Damage resulting from the operation of supplies that overfill or leak due to improper
storage, inappropriate cleaning agents or other damaging chemical components.
- Damage due to improper exposure to extreme temperatures (e.g., freeze fractures,
thermal deformation of components, etc.)
- Damage from permanent exposure to ultraviolet radiation.
- Damage caused by inadequate maintenance.
- Any damage caused by failure to follow the instruction manual
12
EN