pico Technology PicoScope 3000E Serie Guia Del Usuario página 8

PicoScope 3000E Series oscilloscopes
External DC power supply
Voltage
5 V
All models
Take care to avoid mechanical stress or tight bend radii for all connected leads, including
all coaxial leads and connectors. Mishandling will cause deformation and will degrade
performance and measurement accuracy.
2.5 Environment
This product is for indoor or outdoor use, in dry locations only. The product's external mains
power supply (if required) is for indoor use only.
To prevent injury or death, do not use in wet or damp conditions, or near explosive gas or
vapor.
To prevent damage, always use and store your oscilloscope in appropriate environments.
Storage
–20 to +60 °C
Temperature
Humidity
5 to 95 %RH
(non-condensing)
Altitude
EN 61010 pollution degree 2: "only non-conductive pollution occurs
except that occasionally a temporary conductivity caused by
Pollution degree
4
Current
3 A pk
CAUTION
WARNING
CAUTION
Operating Quoted accuracy
15 to 30 °C
0 to 40 °C
after 20 minutes warm-up
5 to 80 %RH
Up to 2000 m
condensation is expected"
Copyright © 2024 Pico Technology Ltd.
2.6 Care of the product
The product contains no user-serviceable parts. Repair, servicing and adjustment require
specialized test equipment and must only be performed by Pico Technology or an approved
service provider. There may be a charge for these services unless covered by the Pico 昀椀ve-year
warranty.
Inspect the instrument and all probes, connectors, cables and accessories before use for signs
of damage.
To prevent electric shock do not tamper with or disassemble the oscilloscope, case parts,
connectors or accessories.
When cleaning the product, use a soft cloth and a solution of mild soap or detergent in water.
To prevent electric shock, do not allow liquids to enter the oscilloscope casing, as this will
compromise the electronics or insulation inside.
Do not block the air vents at the front and back of the instrument as overheating will damage
the oscilloscope.
Do not insert any objects through the air vents as internal interference will cause damage to
the oscilloscope.
2.7 OEM and long-term applications
If using this PicoScope 3000E Series oscilloscope for OEM applications or other continuous
use, please contact Pico Technology's Technical Support team
+44 (0) 1480 479 164) for advice on power, cooling and ventilation.
WARNING
(support@picotech.com
User's Guide
or
DO380-1