Publicidad
Idiomas disponibles
Idiomas disponibles
545150014
4. Hold the control knob down and press until the pilot flame lights up.
5. Continue to hold the knob down for 20 seconds and release.
If the pilot flame fails to ignite, press down the knob and turn clockwise to OFF. Repeat the steps above.
CHOOSING THE BURNER INTENSITY
1. The pilot flame should be lit and the control knob set to PILOT.
2. Press the knob down and turn counter-clockwise to HIGH.
3. Turn the knob clockwise from HIGH to LOW as needed.
TO TURN OFF THE APPLIANCE
1. Press down the knob and turn to OFF.
2. Turn off the valve on the gas supply cylinder to shut down the heater completely.
MAINTENANCE
To enjoy years of outstanding performance from your appliance, make sure you perform the following
maintenance activities on a regular basis:
Keep exterior surfaces clean.
•
Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
•
While cleaning your unit, be sure to keep the area around the burner and pilot assembly dry
•
at all times. If the gas control is exposed to water in any way, DO NOT try to use it. It must be
replaced.
Airflow must be unobstructed. Keep controls, burner and circulation air passageways clean.
•
Signs of possible blockage include: gas odor with extreme yellow tipping of flame, the
appliance does not reach the desired temperature, the appliance glow is excessively uneven,
the appliance makes popping noises.
Spiders and insects can nest in burner or orifices. This can damage the appliance and render it
•
unsafe for use. Clean burner holes by using a heavy duty pipe cleaner. Compressed air may
help clear away smaller particles.
Carbon deposits may create a fire hazard. If any carbon deposits develop, clean dome and
•
engine with warm soapy water.
Note: in a salt-air environment (such as near the sea), corrosion occurs more quickly than normal.
Frequently check the corroded areas and repair them promptly.
EN
11
Publicidad
