Arregui Arm050835 Guia De Inicio Rapido página 8

IMPORTANT
• Never store the emergency keys in the safe!
• If the batteries are low, the safe will emit 5 short beeps after
use. Please replace the batteries as soon as possible.
1.INITIALISING THE SYSTEM
1.1 Insert four alkaline 1.5 V batteries (AA type) into the
battery holder located at the back of the door, ensuring
correct polarity.
1.2 Press and hold the reset button "A" for 2–3 seconds. The
safe will emit a long beep, and the blue light will turn on.
Afterwards, the user password will be initialised to the
original value, "1234", fingerprint records will be cleared,
and no fingerprint will be able to open the door.
2. SETTING OR CHANGING THE USER PASSWORD
2.1 Press the "A" button and the safe will emit a beep.
2.2 Enter your user password, consisting of 3 to 8 digits,
while the blue light is blinking.
2.3 Press the "#" key and the safe will emit 2 short beeps.
2.4 Re-enter your password and press the "#" key..
If you enter the same password twice, and the safe emits a
long beep, it means your new password has been successfully
configured.
If you enter a different password twice, the safe will emit 3
short beeps, and the red light will flash
External USB type-C
power socket
Operation
otification light
Fingerprint reader
Reset button
integrated into the
same light unit located
behind the door near
the hinge
3. SETTING UP FINGERPRINT RECOGNITION
3.1 Press the "A" button and the safe will emit a beep.
3.2 Place your finger in the centre of the collector while the
blue light is blinking. The safe will emit a short beep.
3.3 Repeat with the same finger two more times and the safe
will emit a long beep, indicating that the fingerprint has
been successfully configured.
3.4 You can programme a maximum of 30 different
fingerprints consecutively.
4. OPENING THE SAFE
Opening with electronic code:
4.1.1 Press "#".
4.1.2 Enter your password.
4.1.3 Press "#" again; the blue light will turn on, and the inside
light will stay on for 20 seconds.
4.1.4 Turn the handle clockwise and open the safe.
Opening with fingerprint:
4.2.1 Place your finger in the centre of the fingerprint reader;
the blue light will turn on, and the inside light will stay on
for 20 seconds.
4.2.2 Turn the handle clockwise and open the safe.
If an incorrect password or fingerprint is entered, the red light
will turn on, and the safe will emit 2 short beeps. If the entry
fails 5 times consecutively, the alarm will sound for 1 minute.
Inputting the correct password or fingerprint can deactivate
the alarm.
5. CLOSING THE SAFE
5.1 Close the door.
5.2 Turn the handle anti-clockwise and close the safe.
6. OPENING THE INNER COMPARTMENT
The safe includes an inner compartment. To open it, insert the
key and turn it clockwise.
7. ADJUSTING THE SILENCER FUNCTION
Press "1" and hold it for about 3 seconds; the blue light will
turn on, and the entry sound will be correctly silenced.
Press "1" and hold it for about 3 seconds; the safe will emit a
long beep with the blue light on, and the entry sound will be
restored.
8. ADJUSTING THE VIBRATION ALARM
FUNCTION
Press "9"; the safe will emit a long beep with the red light
on, and the system will enter the anti-theft alarm state after
15 seconds. The alarm will sound for 60 seconds if any
movement or impact occurs. Inputting the correct password
or fingerprint will deactivate the alarm.
En