Blooboost 545150017 Manual Del Usuario página 69

545150017
GAS REQUIREMENTS
Use propane only.
•
The pressure regulator and hose assembly used must conform to local standard codes.
•
The installation must conform to local codes, or in the absence of codes, with the standard for
•
storage and handling of propane gases.
A dented, rusted or damaged propane tank may be hazardous and should be checked by your
•
tank supplier.
Never use a propane tank with a damaged valve connection.
•
The life expectancy of the regulator is estimated as 10 years. It is recommended that the
•
regulator is changed within 10 years of the manufacturing date or earlier if local regulations
require it.
The appliance must use an EN16129 approved gas regulator and EN16436-1 approved gas hose
•
with a length of 50cm.
It is strictly prohibited to use adjustable pressure.
•
The hose used must conform to the relevant standard for the country of use. A worn or
•
damaged hose must be replaced. Ensure that the hose is not obstructed nor kinked. It is
recommended that the hose is changed within 1 year of the date of manufacture or earlier if
local laws require it.
Never connect this appliance to an unregulated gas source.
•
Always perform a leak test on gas connections whenever a cylinder is connected. If bubbles
•
form in the leak test solution, do not use the appliance. Never use a flame to test for leaks.
Use a 30mbar propane regulator for propane or butane/propane mixture of I3B/P(30).
•
Use a 37mbar propane regulator for propane of I3P(37).
•
Use a 37mbar propane regulator for propane or butane/propane mixture of I3B/P (37) or I3P
•
(37).
CONNECTING A GAS CYLINDER
Gas cylinder maximum: 15 kg, 65 cm.
•
Never use a gas cylinder with a damaged body, valve, collar, or foot ring. A dented or rusty gas
•
tank may be hazardous and should be checked out by a gas supplier.
When the appliance is not in use, turn the gas cylinder OFF.
•
Only change gas cylinders outdoors or in a well ventilated area away from naked flames and
•
any other source of ignition (candle, cigarettes, other flame producing appliance....).
The gas cylinder must always be used in an upright position.
•
Tighten all connections firmly and with a spanner where appropriate. The cylinder should be
•
located on the cylinder base.
EN
11