Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the filter bag
1. Unlock and remove the filter cover.
2. Insert the flange of the filter bag into
the intake and swing it upwards.
Illustration F
3. Pull the opening of the filter bag over
the suction connection as far as it
will go. The locking mechanism of
the filter bag engages.
Illustration G
4. Insert the filter cover and engage
audibly.
Operation
Switch on the device
1. Switch on the device at the main
switch.
Eco-Mode
Eco button (energy-saving mode): The
device works with reduced suction per-
formance. The battery run time is ex-
tended.
1. To activate Eco-mode: Actuate the
Eco button.
2. To switch off Eco-mode: Actuate the
Eco button repeatedly.
Adjusting the suction power
Note
Reduce the suction power at the con-
trol dial to reduce the pushing force on
deep-pile carpets. Close the suction
control again after working on high-pile
carpets, otherwise the brush motor
may not start.
1. Adjust the suction power (min-max)
via the rotary control.
Roller brush operation
ATTENTION
Device is operated too long on the
same spot
Risk of damage to the floor covering
Only operate the device briefly on the
same spot.
10
1. Unlock brush head. While doing so,
step on the tread and swing the han-
dle backwards. The roller brush is
switched on.
2. Perform cleaning.
3. Work interruption/end of cleaning:
Lock the brush head. While doing
so, step on the tread and swing the
handle forward. The roller brush is
switched off.
Semi-automatic brush cleaning
Note
The semi-automatic brush cleaning
can only be switched on when the de-
vice is switched on.
Note
The semi-automatic brush cleaning
should be operated at least once a day,
depending on the application, to re-
move light soiling. For heavier soiling,
see "Cleaning the roller brush manual-
ly".
Recommendation for use of brush
cleaning:
● For very heavily frequented areas
(e.g. in schools), after the full-sur-
face cleaning of approx. 50 m²
● For areas with average traffic (e.g.
offices), after the full-surface clean-
ing of approx. 1,000 m²
● for less frequented areas (e.g. hotel
rooms), approx. 1x daily
1. Press the foot button of the semi-au-
tomatic brush cleaning. Step on the
foot pedal 3 times for 5 seconds, but
not longer than 20 seconds without
interruption. This results in system-
related noise development.
Suction pipe operation
Note
For cleaning, for example, edges, ledg-
es, niches, corners.
English
Publicidad
