Publicidad
Idiomas disponibles
Idiomas disponibles
ClickID Snap 10 Photo Frame prepare for set-up.
Remove all packaging and prepare the frame for use. Unwind the power cable,
insert one end into the frame, and then plug the cable supplied to mains power
supply.
Press the 'ON/OFF' button (Ref.1) to switch on.
Attention: When the ClickID Snap 10 Photo Frame is in use, DO NOT REMOVE the
power cable. To switch OFF, press the 'ON/OFF' button (Ref.1), and only after
switching off, disconnect from the power source.
Getting Started
If you are new to using ClickID Snap 10 Photo frame, then start by following the
quick setup or follow the on-screen step-by-step guide when powering the frame
on for the first time:
ClickID Snap 10 Photo Frame Quick Setup
Once the ClickID Snap 10 Photo frame is switched on for the first time, a step-by-
step guide will come up for you to follow:
Select a language to be used on the ClickID Snap 10 Photo Frame.
•
Connect your frame to your WIFI Internet Network.
•
Once connected, you might be asked to download and update your ClickID
•
Snap 10 Photo Frame software if there is a newer version available. It is
recommended to update your photo frame before continuing your set-up.
Enter your frame name, and the location where you have placed your frame
•
e.g. 'John Doe' and 'Living Room'.
Finally set the time zone if required also set the time and date.
•
ClickID Snap 10 Set-Up
EN
7
Publicidad
