Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
5. UNPACKING
When unpacking, check to make sure that the item is intact and undamaged.
INITIAL SET UP INSTRUCTIONS
Read the entire Important Safety Information section at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Warning. To prevent serious injury from accidental operation:
Turn the Power Switch (11) of the Plasma Cutter to its "OFF" position and unplug the plasma cutter from its
electrical outlet before assembling or making any adjustments to the plasma cutter.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly
Diagram near the end of this manual.
ASSEMBLY
1. The air regulator is set inside. See picture below, A male Quick Release Adapter is mounted on the Air
Pressure Regulator inside the Plasma Cutter. Attach your compressor's air supply hose to the Quick
Release Adapter. Then, adjust your compressor to deliver 0.4 to 0.5 MPA compressed air.
Air pressure gauge
LEDs
Earth clamp connection
2. During operation, you can regulate air pressure through the Plasma Cutter by adjusting the Knob located on the Air
Pressure Regulator.
Amperage adjust-
ment potentiometer
Compressed air pressure
regulation knob
Cut torch
13
Publicidad
