cecotec BOLERO SQUAD 2001 Manual De Instrucciones página 70

ENGLISH
Dirt on the 1. Unplug the induction hob from
touch controls.
2. Absorb the dirt.
3. Clean the touch control area
4. Dry the area completely with a
5. Reconnect the induction hob
6. TROUBLESHOOTING
Problem
The induction hob does
not turn on.
The touch controls do
not respond, or the LED
display malfunctions.
The LED does not turn
on when the unit is
connected.
70
the mains.
with a sponge or a damp and
clean cloth.
paper towel.
to the mains if you wish to
continue using it.
Possible causes
There is no power supply.
The buttons are locked.
The display is damaged.
There is no electricity.
The auxiliary power board and
the board connected to the
display malfunction.
The auxiliary power board is
damaged.
The display is damaged.
The induction hob may beep and turn
off, and the touch controls will not
work while there is liquid on them.
Make sure you dry the touch control
area before turning on the induction
hob again.
Possible solutions
Make sure the hob is connected
to the mains and it is on.
Check if there has been a
power failure. If the problem
persists, please contact the
official Cecotec Technical
Support Service.
Unlock the buttons. Check the
"Locking the buttons" section
for instructions.
Replace the display board.
Check if the plug is properly
connected to the mains and if
the latter works.
Check the connections.
Replace the power board.
Replace the display board.