Parkside PRFMA 20-Li A1 Instrucciones De Funcionamiento página 34

GB MT
(3), select "All stations" to obtain a full
list of stations or "Only strong stations"
to obtain only stations with a strong
signal.
3. Press the volume control knob (3) to
confirm the settings.
Audio settings
1. Select "Audio settings" in the menu.
2. Using the NEXT / PREV buttons
(11/14) or the volume control knob
(3), select "Stereo possible" to play
back stereo signals when available or
"Mono only" to play back mono sig-
nals only.
3. Press the volume control knob (3) to
confirm the settings.
The description of the settings under
"System" can be found in the sec-
tion "System settings for all modes".
Special settings for AM
1. Press and hold the Info/Advanced but-
ton (9) for approx. 2 seconds to access
the Settings menu.
2. Scroll using the NEXT / PREV buttons
(11/14) or the volume control knob
(3).
3. Push the volume control knob (3) to
confirm the selection.
AM step
1. Select "AM steps" in the menu.
2. Use the NEXT / PREV buttons (11/14)
or the volume control (3) to select "10
KHz" or "9 KHz" steps for the manual
station setting.
3. Press the volume control knob (3) to
confirm the settings.
34
The description of the settings under
"System" can be found in the sec-
tion "System settings".
AUX-In operation
Connection via the AUX
connection on the front of
the device
1. Plug the AUX cable (21) into the AUX
connector (6) on the front of the device.
2. Connect the AUX cable (21) to a play-
back device.
As soon as an AUX cable (21) is connect-
ed to the AUX connection (6) on the front
of the device, the radio automatically
switches to this input.
The device switches off automatical-
ly if you pause playback for more
than 5 minutes.
Mute
The Mute function deactivates the sound
output while playback continues.
To activate this, press the Mute button (13).
To deactivate this, press the Mute button
(13) again.
The active mute function is shown on the
display (2).
Operating via
Bluetooth
®
Connecting via Bluetooth
1. Press the source button (7) repeatedly
until the display (2) shows "Bluetooth".
2. The display (2) flashes "Not Connect-
ed".
®