Teka HLC 847 C Guía De Uso página 15

Teka Hydroclean
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to
accumulate. Clean the oven frequently.
PROGRAMING THE TEKA HYDROCLEAN
FUNCTION
Do not pour water into a hot oven as this
can damage the enamel of the oven.
Always run the cycle on a cold oven. The
result could be affected and the varnish
damaged if it is run when the oven is too hot.
First remove the trays and all accessories
from the oven interior, including the tray
supports and telescopic guide rails.
To do this, follow the instructions in the
installation and
accompanying the oven.
1. With the oven cold, spread a cloth out on
the bottom of the oven.
2. Gently pour 200 ml of water into the
bottom of the oven cavity.
®
function
maintenance guide
For best results, add a teaspoon of mild
washing up detergent to the glass of
water before pouring onto the cloth
®
3. Turn the control dial to position
4. Set the temperature to 90º C.
5. Program a duration of 4 minutes on the
timer.
6. After 4 minutes, an alarm will sound and
the oven will stop heating.
7. Turn the control dial to position
8. Wait for about 20 minutes for the interior
of the oven to cool.
Do not open the oven until the cooling
phase is complete.
This is necessary for the Hydroclean
function to work properly.
9. Any traces of dirt and excess water can
now be removed from the oven with the
damp cloth.
The Hydroclean
temperature. However, cooling times can
vary depending on the room temperature.
Before touching the inside surface of the
oven, make sure that it has cooled
properly.
If a deeper clean is required after using the
®
Hydroclean function, use neutral detergents
and non-abrasive sponges.
®
function takes place at a low
EN
.
.
®
15