Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND ASSEMBLY
1.
Create a space in the wall for the single lever mixer and its plastic protective casings. (Fig.1)
2.
Lodge the cold water supply pipes to the lower right hand side, while the hot water pipes to
the left. On both the top and bottom areas, lodge the sanitary supply pipes. (Fig.2)
3. To prevent impurities or debris from entering the mixer and causing operating
problems, flush out the system before connecting the supply pipers. The
installation of a special inflow filter is recommended.
4.
Place the single lever mixer complete with plastic protective casings, paying attention that the
surface level of the tiles-finished wall is within 44.3 and 69.3 mm. (Fig.3)
5.
Complete the connections as shown in Figure 4.
6.
Check the plant and verify the absence of any leak
7.
Clad the walls, see Fig. 5.
8.
Remove the plastic protections (Fig. 6).
9.
Remove any filth/impurities on the surface of the single lever mixer and/or tiles (Fig.7)
10. Insert the mixer bush (4), screw the cover ferrule (11) and the diverter bush (7). (Fig. 8)
11. Remove the film from the sponge in the backside of the cover plate (10). Insert the plate on the
bush and on the diverter sticking out of the concealed part of the mixer and push the plate
against the wall (fig. 9)
12. Insert the spring (6) on the pivot of the diverter (5). Insert the mixing and supply handle (12)
respecting the orientation indicated in fig. 10 / 10_A / 10_B. Fix the handle with the special
threaded pin (13) and insert the cap (14).
13. Position the knob (15) on the pivot of the diverter (5) and screw the knob while pressing (fig.
11)
14. Clean the mounted components with care (Fig. 12).
13
Publicidad
