Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND REPAIRS
Premise: Continuous and extended use over time and the properties of the local water supply may lead to
a loss of efficiency of the cartridge. Therefore, maintenance, cleaning or replacement may be necessary .
1.
Close every water inlet connections to the mixer.
2.
Remove the cap (14) and unscrew the threaded pin (13); extract the mixing/on-off handle (12); only for
version with square exposed parts unscrew also the knob (15); finally remove the cover plate (10). (fig. 16)
3.
Unscrew the cover ferrule (11), pull out the mixer bush (4), then unscrew the clamping ferrule
of the mixer cartridge (3). It is recommended to protect the contact between the operating
wrench and the threaded bush and the threaded ring.
4.
Extract the mixing cartridge (2):
In case of maintenance only, remove possible dirty residues or scales deposited inside the
cartridge seat. Immerse the cartridge in a water and vinegar solution (50% + 50%) for about 12
hours, in order to remove lime scale and impurities, then continue from point no. 5;
In case of replacement of the cartridge, start from point no. 5;
5.
Insert the new mixing cartridge (2) paying attention to the 2 pins sticking out from the base;
they must be entered in their specific seats (fig. 18). Screw the clamping ferrule for the cartridge
(3) and tighten by applying a 12 Nm torque.
6.
Insert the mixer bush (4) and screw the cover ferrule (11).
7.
Unscrew the diverter cartridge (5) and remove any residue or impurities in its seat; (Fig.17).
8.
Screw in the new diverter cartridge (5) and lock into place. (For version with square exposed
parts, assemble the knob only after positioning of the cover plate).
9.
Open the water inlet.
10. Replace the cover (10).
11. Insert the mixing and supply handle (12) respecting the orientation indicated in fig. 16. Fix
the handle with the special threaded pin (13) and insert the cap (14). For version with square
exposed parts, screw also the knob (15).
12. Clean carefully with a cloth.
CLEANING
To keep the material's appearance as long as possible, a few guidelines must be followed.
Cleaning metal parts: water contains calcium that deposits on surfaces and forms unpleasant
spots. For routine cleaning,simply use a damp cloth with a little soap, rinse and dry. Calcium spots
can therefore be avoided by drying after use.
Important note: Using only a soap-based detergent is recommended. Never use abrasive detergents
or disinfectants or those containing alcohol, hydrochloric acid or phosphoric acid.
Dear Customer, we would like to remind you that the warranty on our product's surface is not valid if
the material undergoes treatment different than that suggested. The warranty does not cover any
damage due to deposits of calcium or impurities.
WARRANTY TERMS
Dear Customer,
We congratulate you and thank you for choosing a Bossini quality product
The product is guaranteed against any defects due to manufacturing faults as specified
hereunder:
1) 5 Years casting defects or porosity
2) 2 Years chromium plated surfaces defects (not including defects / deterioration caused by use of
abrasive or acid detergents)
24
Publicidad
