cecotec ENERGYSILENCE AERO 3600 INVISIBLE NATURAL STYLE Manual De Instrucciones página 50

ENGLISH
- When the fan is switched on and starts running in either direction (clockwise or
counterclockwise), it will stop and change direction several times. This is normal. The fan
will take some time to perform the selected function and to start up regularly.
- Reconnect the mains supply from the electrical switchboard in the house.
- Remove the battery-compartment cover of the remote control, insert the batteries, and
replace the cover.
Note:
- The remote control is powered by two AAA 1.5 V batteries.
- If the fan is not to be used for a long period of time, store the remote control in a dry place
where it will not be exposed to heat or direct sunlight. Also remove the batteries.
5. CLEANING AND MAINTENANCE
- Clean your fan periodically.
- When cleaning, only use a soft brush or lint-free cloth to avoid scratching the finish.
- Abrasive cleaning agents are not necessary and should be avoided in order not to damage
the finish.
WARNING: do not use solvents to clean the fan. Doing so may result in a risk of electric shock.
RECOMMENDATION: periodically check that the blades are securely fastened to the motor with
the screws.
6. TROUBLESHOOTING
- Note that not all ceiling fans are the same (not even those that are the same model), some
move more than others.
- The fact that the fan moves a couple of centimetres does not indicate that it will fall over.
- Even if all blades are ballasted and grouped by weight, it is impossible to completely avoid
wobble. This is not a problem. Ceiling fans tend to move during operation.
To reduce wobble, try the following:
1. Check that all of the blade mounting screws are tightened and secure.
2. Fan wobble may be caused by the unevenness of the fan blades. To check the blade level,
measure the distance from each blade tip to the ceiling. If measurements are irregular:
Be sure the blade mount screws are not too tight or too loose, which may cause wobbling
-
due to an unlevelled blade tip.
- A deformed blade can cause wobbling. Check by removing the blade and placing on a flat
surface.
50 ENERGYSILENCE AERO 3600 INVISIBLE NATURAL STYLE