Fulgor Milano F6IRT487S1 Instrucciones Para La Instalación página 11

The surface of the entire back wall above the range and below the hood must be covered with a noncombustible material.
*Consult local code for exact location requirements.
Note: Clearances to non-combustible materials must
conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI
Z223.1/NFPA 54.
Minimum clearances:
Above cooking surface (above 36" [91.4 cm])
• Sides 3" (7.6 cm)
• Within 3" (7.6 cm) side clearance, wall cabinets no
deeper than 13" (33.0 cm) must be minimum 18" (45.7
cm) above cooking surface.
• Wall cabinets directly above product must be a minimum
of 30" (76.2 cm) above cooking surface, no deeper than
13" (33.0 cm).
• Rear - 0" with 3" (7.6 cm) backguard.
Vent hood Combinations:
It is recommended that these rangetop be installed in
conjunction with a suitable overhead vent hood.
Install a hood with at least 450 CFM.
Due to the high heat capacity of this unit, particular attention
should be paid to the hood and ductwork installation to assure
it meets local building codes.
WARNING
Clearances to horizontal surfaces above the rangetop,
measured to the cooking surface are below. Failure to
comply may result in fire hazard.
• Installations without a hood require 30" (76 cm) minimum
to combustibles.
• For other installations with a hood, refer to the hood
installation instructions for specific hood clearances.
2 - Product Dimensions and Cutout Requirements
CUTOUT REQUIREMENTS
ADDITIONAL CLEARANCES:
For island installation, maintain 2-½ in. minimum from
cutout to back edge of countertop and 3 in. minimum from
cutout to side edges of countertop (see top view).
Due to the weight and size of the range and to reduce the
risk of personal injury or damage to the product:
TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION.
FLUSH ISLAND TRIM INSTALLATION
BACK
min 3" (7.6)
CAUTION
EN
min 3" (7.6)
7