Publicidad
Idiomas disponibles
Idiomas disponibles
USB Ports Fault Conditions
When the USB Ports are in use, the unit will monitor for the
following fault conditions (on all Ports):
•
If a Low Battery Voltage Fault occurs, the USB Ports will
automatically shut down, only one Battery Status LED Indicator
flashes for a short period of time before automatic shut down
occurs.
•
If an Overload Fault or a Short-circuit occurs, the USB Ports
will automatically shut down immediately.
•
If the battery of the unit overheats or is too cold, the USB
Ports automatically shut down.
•
If the battery is overheated, the Battery Status LED Indicators
light solid and the Overheat Indicator lights solid as well. After
a short time of period, the unit will automatically shut down.
•
If the battery is too cold, the Battery Status LED Indicators light
solid and the Cold Indicator lights solid as well. After a short
periods of time, the unit will automatically shut down.
In any of these cases, disconnect the USB-powered device
immediately.
- Make sure the unit does not need to be recharged.
- Allow the unit to cool down for several minutes before attempting
to use the USB Ports again.
- If a fault occurs again, make sure that the total draw of all USB
devices plugged into the USB Ports does not exceed the maximum
rating.
- If an individual USB device is within specifications and the fault
occurs, have the USB device checked for malfunction and do not
continue to use it with these USB Ports.
Notes: This unit's USB Ports do not support data communication.
They only provide power to external USB-powered devices.
Some USB-powered household electronics may not operate with
this unit's USB Ports. Check the manual of the corresponding
electronic device (including a cell phone, tablet, etc.) to confirm that
it can be used with this unit's type of USB Ports.
OPERATING THE 120V AC/USB CHARGING
ADAPTER'S USB PORT
Plug the 120V AC/USB Charging Adapter into a (powered) standard
North American 120 volt 60Hz outlet. Simply plug a USB device into
the USB outlet and operate normally.
WARNING –To reduce the risk of injury or property damage:
Always plug the 120V AC/USB Charging Adapter to a standard
North American 120 volt 60Hz outlet before plugging any devices
into it.
OPERATING THE SUPPLIED 12V DC/USB
CHARGING ADAPTER'S USB PORT
Plug the 12V DC/USB Charging Adapter into a vehicle's 12 volt
DC accessory outlet or other functioning 12 volt DC power source.
Simply plug a USB device into the USB outlet and operate normally.
Note: Some vehicles require that the ignition be switched to the
accessory outlet position in order to power the accessory outlet.
OPERATING THE LED AREA LIGHT
The LED Area Light is controlled by the LED Area Light On/Off
Power Button. Refer to the "Features" section to locate.
1. Press the Power Button once to turn the LED Area Light on at
low setting mode.
2. Press the Power Button a second time to use the LED Area Light
at high setting mode.
14
Publicidad
