Publicidad
CLEANING
3. Clean with care the internal part of the squeegee inlet eliminating
eventual dirt residuals.
4. Clean with care the squeegee rubbers.
5. Reassemble all parts paying attention to put the washers (3) into
position, they are two for each knob, so that they are assembled one
under and the other on each of the two slots present on the support.
WEEKLY MAINTENANCE
Rear Squeegee Rubber Check
Check the squeegee rubber wear and eventually turn or replace it.
For the replacement it is necessary to:
1. Lift the squeegee (see under paragraph "STOP OF THE MACHINE AFTER
CLEANING OPERATION").
2. Release the hooks (1).
3. Unscrew the wing nuts (2) to take off the terminals of the outer rubber holder
blades (3) and then take off the central rubber holder blade (4).
4. Take off the rubber (5), turn it to a new side or replace it.
To reassemble the squeegee, reverse the operations above.
28
Publicidad
