Festina CONNECTED D MOVT FKS934 Guía Rápida página 5

EC Declaration of Conformity
We, FESTINA LOTUS SA, of C/Velázquez nº 150, 3º 1ª 28002 Madrid (Spain) declare
under our sole responsibility that our product Festina Connected D watch of model
MOVT FKS934 is in conformity to the essential requirements and other relevant
requirements of the RE Directive 2014/53/EU: EN 62479:2010, EN 50663:2017, EN
62368-1:2014+A11:2017,
EN 55032:2015+A1:2020, EN IEC 61000-3-2:2019+A1:2021, EN 61000-3-
3:2013+A1:2019, EN 55035:2017+A11:2020, ETSI EN 301 489-1 V2.2.3:2019, ETSI
EN 301 489-17 V3.2.4:2020, ETSI EN 300 328 V2.2.2:2019. RoHS Directive 2011/65/EU
Annex II and its amendment (EU) 2015/863. REACH Regulation (EC) No.1907/2006.
Barcelona, August 2023
Carlos Casas, Legal
For full declaration of conformity, please go to https://festinagroup.com/certification/
FCC Declaration of Conformity
FCC ID: 2A8P6-FKS934
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate the equipment. Note: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can
be used in portable exposure condition without restriction.