cecotec ENERGYSILENCE 1000 CYCLONE SMART Manual Del Usuario página 38

ENGLISH
3 ASSEMBLING THE APPLIANCE
.
1. Remove the fan from its packaging. Mount it correctly following the steps in this
instruction manual. Store packaging materials in a safe place.
2. Check that the parts included in the box match those listed in this manual.
Then, proceed to mount it.
Place the fan on the tube as shown in Fig. 2. To fix it securely, turn it clockwise.
3.
Place the tube on the base as shown in Fig. 3. Fix it with the provided screw.
4.
5. When the fan is already mounted, place it on a flat surface.
4. OPERATION
1. Plug the fan into the mains. A beep will sound and the
This means that the fan has enter standby mode.
NOTE: do not use wet hands to plug and unplug the fan from the power cable to avoid the
danger of electric shock.
Disconnect the power plug when relocating the fan.
2. When the fan is in standby mode, press the
fan will start at medium speed. The corresponding indicator light and the decorative light
will light up. Press this button again to return the fan to standby mode.
3. Press the button to change speed.
The fan has 3 speeds:
- Low speed (L)
- Medium speed (M)
- High speed (H)
By default, the fan will start at medium speed (M).
NOTE: each time you select a speed, the corresponding indicator light (L, H, M) will light up,
the fan will start at the selected speed and the decorative light will also light up (this light
will always be on, it will only switch off when the fan is in standby mode, or you switch it off
from the remote control).
4. Press the
will add one hour. When it does so, an indicator light will light up (1H, 2H, 4H).
38
ENERGYSILENCE 1000 CYCLONE SMART
button to set the timer (between 1 and 7 hours). Each press of this button
indicator light will light up.
button to start the fan. By default, the