Bestway 68087 Manual De Usuario página 3

IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
WARNING
Keep all flames and heat sources away from this tent fabric. We recommend that you always position your tent upwind
from a camp fire. This will reduce the chances of having embers land on your tent. In case of fire, please find the exit to
escape from the fire. Never set up the tent near the river, under the tree of other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to avoid suffocation.
SAVE THESE INSTRUCTIONS
TECHNICAL SAFETY INSTRUCTIONS
Any use other than that described or any modification of the product is not permissible and may result in injury and/or
damage to the product. The manufacturer is not liable for damage caused by improper use. The product is not intended for
commercial use.
PRODUCT DESCRIPTIONS
Model No.
68087
L
SETUP INSTRUCTIONS
PARTS & TOOLS NEEDED
Compare the parts in your box to the parts listed in this manual. Verify that the equipment components represent
the model that you had intended to purchase.
ASSEMBLY INSTRUCTIONS
1. Take the tent A out of the carry bag D and remove the strap.
WARNING: The tent A is under pressure and should be handled with caution. Release the tent A away from you.
2. Hammer the pegs B into the ground through the rings of the tent A corners.
3. Tie one end of the guy ropes C onto the four corner hoops of tent A.
4. Tie the other end onto the tent pegs B and fasten them by inserting the tent pegs B into the ground.
NOTE: Ensure that guy ropes C are at an angle of about 45°. Do not pull the guy ropes C too tight.
REPACKING INSTRUCTIONS
For repacking instructions, follow the illustrations inside the manual. Drawings are for illustration purposes only.
May not reflect actual product. Not to scale.
1. Fold the lower point of the tent to the higher one.
2. Continue folding the two sides.
3. Turn the folded structure by 90 degrees.
4. Hold point C with one hand.
5. Press the upper point A towards the lower point B.
6. The previous operation will create two circles. Fold the external circle towards point D.
7. Continue folding the second circle above the previous circle.
8. Sort the packed tent.
9. Strap the tent and store it in the carry bag.
MAINTENANCE & STORAGE
1. Clean the tent and remove any stains with a sponge and cool water. Use non-detergent soap for serious cleaning.
2. Never machine wash or machine dry the tent. Hand wash and air dry.
3. Allow all parts to dry thoroughly before you repack the tent. This will prevent the formation of mold, bad odors
and discoloration.
4. Store the tent in a dry place with a moderate temperature between 10ºC / 50ºF and 38ºC / 100ºF, out of reach
of children.
OWNER'S MANUAL
Tent Dimensions
2.10 m x 2.40 m x 1.00 m /
6'11" x 7'10" x 39"
W
Pitching Dimensions
2.20 m x 2.50 m /
7'3" x 8'3"
H
3