Maytag MGRH865QDS12 Guía De Uso Y Cuidado página 13

Torecall t hetimeofdaywhen another timefunction is
showing, press theClockpad.
Clock timecannot b echanged when theoven hasbeen
programmed forDelay Cook or Delay Clean or Cook & Hold.
To cancel the Clock display:
If you do not want the time of day to display:
Press and hold the CANCEL and Clock
pads for three seconds. The time of day will I_,,LAINLL_
disappear from the display. |_
When the clock display is canceled press the L
/
Clock pad to briefly display the time of day.
When the clock display is canceled, after 15 minutes, the oven
control will go into Standby Mode to save energy. The displaywill
be blank and the oven light will not operate. To "wake up" the
control from Standby Mode, press any touchpad. A double beep
will sound.
To restore the Clock display:
Press and hold tile CANCEL and Clock pads for three
seconds. The time of day will reappear in the display.
Timer
The timer can be set frorn one minute (0:01) up to 99 hours
and 59 minutes (99:59).
The timer can be used independently of any other oven
activity. It can also be set while another oven function
is operating.
The timer does not control the oven. It only controls a beeper.
To set the Timer:
1. Press the Timer pad.
• 0:00 and TIMER flash in the display.
2. Press the appropriate number pads until the correct time
appears in the display.
• The colon and TIMER will continue to flash.
3. Press Timer pad again or wait four seconds.
° The colon stops flashing and the time begins
counting down.
• The last minute of the timer countdown will be displayed
in seconds.
4. At the end of the set time, one long beep will sound and
"End" will be displayed.
5. Press the Timer pad to clear the display.
To cancel the Timer:
1. Press and hold the Timer pad for three seconds.
OR
2. Press the Timer pad and press '0' using
the number pads.
m0
Autoset
Locking the Control
and Oven Door
The touchpad and oven door can be locked for safety,
cleaning, or to prevent unwanted use. The touchpads will not
function when locked.
If the oven is currently in use, the touchpads and door cannot
be locked.
The current time of day will remain in the display when the
touchpads and door are locked.
To lock:
Press and hold the CANCEL and Cook &
Hold pads for three seconds. (Press the
CANCEL
CANCEL pad first.)
° OFF appears in the display
° LOCK flashes while the door is
locking.
To unlock:
Press and hold the CANCEL and Cook & Hold pads for three
seconds. (Press the CANCEL pad first.) OFF disappears from
the display.
Note: The touchpads and oven door cannot be locked if the
oven temperature is 400° F or above.
Fault Codes
BAKE or LOCK may flash rapidly in the display to alert you if
there is an error or a problem. If BAKE or LOCK flash in the
display, press the CANCEL pad. If BAKE or LOCK continue
to flash, disconnect power to the appliance. Wait a few
minutes, and then reconnect power. If the flashing still
continues, disconnect power to the appliance and call an
authorized servicer.
Baking
To set Bake:
1. Press the Bake pad.
Bake
• BAKE will flash.
° 000 will flash in the display.
P_
2. Select the oven temperature. Press the Autoset 0 U
pad for 350° F or the appropriate number pads. Au[oset
• Each additional press of the Autoset 0 pad will increase
the temperature by 25°.
• The oven temperature can be set from 170° to 550 °.
3. Press Bake pad again or wait four seconds.
° BAKE will stop flashing and light in the display.
12