JANE nurse VOYAGER Instrucciones página 14

GB
3
INSTALLATION LOCATION AND ADJUSTMENT OF CHILD
3
.1 The right fitting position in the car
V _ right fitting
Only suitable use in the listed vehicles fitted with 3 point with retractor safety-belts, approved to
ECE Regulation No.16 or other equivalent standards.
3.2 Check whether the height of harness straps is correct
• First step •
Always check that the shoulder are at the correct height for your child. The child's shoulder should
always be below the slot for the harness straps. (The right fitting as the picture shows.)
3.3 Adjust the height of shoulder restraint
Step 1: Loosen the shoulder straps, open the buckle.
Step 2 Pull out the buckle tongues from the chest pad and the slots on the cover and the shell, then
thread them into the corresponding belt slots. Ensure that both of the shoulder belts go through
slots at the same height, and not twisted.
3.4 Operation of buckle
Step 1. Loosen the harness (see point above), open the buckle, and place them down side ways.
Seat your child in the child car seat. Place both shoulder straps over your child's shoulders.
Note: Baby below 5kg using comfort pad and headrest pad.
Baby above 5 kg, only using headrest pad.
Step 2. Put the two metal sections of the buckle connectors together (fig. 1), Slot the two buckle
connectors into the slot in the top of the buckle until they "click" into place.
Check the harness is correctly locked by pulling the shoulder straps upwards.
• First step • Second step • Third step
3.5 Tighten the harness restraint
Pull the adjustment straps until the harness straps are totally tight.
The shoulder restraint shall be adjusted as tightly as possible without causing discomfort to your
child. Check whether the straps are adjusted tightly enough and not twisted when the child is pla-
ced in the seat. Be sure the distance between the shoulder straps and shoulder is less than 1 cm.
The lab strap shall be worn low down, so that the pelvis is firmly engaged. The loose straps are very
dangerous for the child.
3.6 Loosen the harness restraint
Find the right position of harness strap adjuster. (See position 1 as showed in the left picture)
Keep pressing down the harness straps adjuster by one hand, meanwhile grip two shoulder straps
and pull them towards you by the other hand.
With the operation mentioned above, you can loosen the harness restraint and adjust as you requi-
red.
3.7 Adjust the handle
Make sure all the belts position is right and they have not become twisted. Also check that the
cover is not impeding the movement or fit of the belt webbing in any way.
To release your baby car seat following the above instructions in reverse order.
The handle for the baby car seat can be snapped into 4 stable positions. To adjust the handle,
please press the red buttons of the handle on both side at the same time. Now it can be rotated.
Position one. Rearward facing installed in the car. This position (only this position) is suitable for the
baby car seat installed on the vehicle seat.
Position two. Straight up for carrying.
Position three. Handle clicked back to initiate the rocking feature.
Position four. Down to support baby for feeding and play.
Ensure that the handle is locked in a position, the harness is correctly fitted and the buckle faste-
ned before carrying your car seat.
14
X _ wrong fitting
Too high • CORRECT