Ryobi ST-1200 Manual De Utilización página 9

9. DRIVING SCREWS, DRILLING AND IMPACT DRILLING
• Insert the drill bit or screwdriver bit using the quick clamping drill chuck.
• Depending on the your work, select the appropriate speed (3) and the screwdriving, drilling or impact drilling function (2).
Screwing
Speed 1: suitable for large screws
Speed 2: suitable for small screws
The torque is set by means of an adjusting ring. The contact pressure has no influence on the torque. Screw-driving can be
carried out from settings 1 – 24.The lowest torque is obtained on setting 1.
The power tool must be switched off when the screwdriver bit is placed in the screw/nut.
You will hear a click when the adjusting ring reaches the selected torque position; you can then let go of the ring (5).
Drilling
Speed 1: suitable for drilling large holes
Speed 2: suitable for drilling small holes.
Turn the torque setting to the "drilling" symbol.
Impact drilling
STP-1200 STP-1201
STP-1440 STP-1441
STP-1800 STP-1801
Turn the torque setting to the "impact drilling" symbol.
10. CHANGING THE DRILL CHUCK
Risk of injury
by switching on the tool unintentionally.
Before changing the drill chuck pull out the battery.
• Turn the setting ring to the "drilling" symbol.
• Select (3) speed 1.
• Open the drill chuck and unscrew the locking screw (Phillips screw, left-hand thread).
• Insert the Allen key into the drill chuck and loosen the drill chuck by giving the key a light tap (right-hand thread).
Reassemble in the reverse sequence.
11. SPECIFICATIONS
Drill/Driver
Motor
Chuck Capacity
Drilling Capacity (in steel/wood)
No load speed (low/high) (rpm)
Torque
Net Weight
Impact Drill/Driver
Motor
Chuck Capacity
Drilling Capacity (in steel/wood)
No load speed (low/high) (rpm)
Impacts per minute
Torque
Net Weight
(in concrete)
ST-1200 ST-1440
ST-1201 ST-1441
700 700
10mm 13mm
10mm/20mm 13mm/32mm
300/0-1000 min -1 0-350/0-1250 min -1
24Nm 30Nm
2.1Kg 2.2Kg
STP-1200 STP-1440
STP-1201 STP-1441
700 700
13mm 13mm
10mm/20mm 13mm/32mm
10mm 10mm
0-300/0-1000 min -1 0-350/0-1250 min -1
0-4810/0-16250 0-5200/0-16900
26Nm 28Nm
2.1Kg 2.2Kg
9
GB
ST1800
ST-1801
700
13mm
13mm/32mm
0-350/01300 min -1
38Nm
2.5Kg
STP-1800
STP-1801
700
13mm
13mm/32mm
10mm
0-350/01300 min -1
0-5200/16900
34Nm
2.5Kg