Publicidad
Idiomas disponibles
Idiomas disponibles
Thank you for purchasing this safe. We advise you to read the
instructions before you install and use the safe to prevent its
improper use from making the guarantee void.
CAUTION!
Do not store the emergency keys in the safe.
1. CHARACTERISTICS OF THE PRODUCT
FRONT DIAGRAM OF THE SAFE
1. Emergency lock
2. Socket for external power supply for battery.
3. Fingerprint reader.
1
3
2. FIRST TIME THE SAFE IS OPENED AND
INSTALLATION OF THE BATTERIES
• Slide the emergency lock cover to the right.
• Insert the emergency key and turn in a clockwise direction
The key may only be removed in the locked position.
Important: once locked, remove the emergency key and keep
it in a safe place (never inside the safe).
•
Open the battery compartment behind the door and
insert 4 1.5V alkaline batteries, making sure the polarity
is correct.
Important: never combine old and new batteries.
3. CONFIGURE AND DELETE FINGERPRINT
a) Configure fingerprint
• Press the "reset" button on the left of the back of the
door.
• You will hear a beep and the fingerprint reader indicator
ring will flash once in green. Hold your finger on the
fingerprint reader until it flashes green and beeps once.
• Repeat this process at least 5 times until you hear 2
consecutive beeps and the green light turns on.
• Make sure that you can open the door with the registered
fingerprint before closing it.
• Up to 29 fingerprints can be registered.
2
External power
supply for battery.
b) Delete all fingerprints
• Press and hold the "reset" button on the left of the back
of the door next to the hinges, the green LED will flash
approx. 15 times and at the end you will hear a long beep,
to indicate all fingerprints have been deleted.
4. OPENING THE SAFE
• Place the same finger on the fingerprint reader and keep it
there until the green light turns off.
• The door will then open automatically and the light inside the
safe will turn on.
5. EMERGENCY OPENING
If your fingerprint does not work or the box runs out of
batteries, use the emergency key to open the safe (see point
2) and then reset code and fingerprint access.
When the battery is running low, the green light will flash,
which means you must change the batteries.
6. CLOSING
Close the door and hold it closed for 3 seconds. The door will
then lock automatically.
7. SAFE LOCKOUT
If there are 5 failed opening attempts in a row, you will hear a
10-second warning sound and you will be unable to try again
for 1 minute.
8. USING THE EXTERNAL BATTERY FEED
To carry out an opening with the external feed, proceed in the
following manner:
• Place 4 x 1,5V (AA) batteries in the external feed.
• Insert the feed connector in the current outlet located
on the lower left of the keypad. The box will emit a long
beep, indicating that it has a feed connection. Do not
remove the feeder until the opening procedure has been
completed.
En
Publicidad
