Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACH THE SWITCH/FASCIA ASSEMBLY
TO THE ROUTER TABLE (FIG. 3 AND
DETAIL 3A)
NOTE: The fascia assembles to the inside of both
the table legs and the router table top.
1. Line up the holes on the fascia with the holes in
the table legs and the two slots on the front of the
router table top.
2. Attach the fascia to the router table top using two
#10-32 x 3/4" long truss head machine screws (42)
and two #10-32 KEPS nuts (31), as shown in Fig. 3.
3. Attach the fascia to the legs using four #10-32 x
3/4" long truss head machine screws (42) and four
#10-32 KEPS nuts (31), as shown in Fig. 3.
4. TIGHTEN all screws SECURELY.
MOUNTING THE ROUTER TABLE TO A WORK SURFACE OR WORKBENCH
Before operating, make sure the
entire unit (table with router installed) is placed on
and secured to a solid, flat, level surface and will
not tip. Use of auxiliary in-feed and out-feed
supports is necessary for long or wide workpieces.
Long workpieces without adequate support can cause
the router table to tip over.
Router Table Assembly
FIG. 3
DETAIL 3A
TOOLS REQUIRED (not included)
• Phillips screwdriver
• Small sized adjustable wrench
• Electric or hand drill with drill bits (depending on
mounting method used)
• Fasteners (not included):
Three methods of attaching the router table to a work
surface or workbench are described on page 12. Select
the method that is most suitable for your needs.
11
#10-32 KEPS
• Four #14, #16, or #18 x 2" pan head wood
screws (for solid wood work surfaces or
workbenches), or
• Four 5/16" pan head machine screws, washers,
and hex nuts, or
• Clamps.
#10-32 x 3/4" TRUSS
NUTS
HEAD SCREWS
Publicidad
