Publicidad
Idiomas disponibles
Idiomas disponibles
TO ADJUST THE FENCE OPENING FOR
ROUTER BIT CLEARANCE (FIG. 27)
1.
Loosen the two fence clamping knobs on both the
right and left side of the upper fence.
2.
Move the lower fences to the desired position rela-
tive to the bit.
3.
Securely retighten the fence clamping knobs.
TO ADJUST THE DEPTH OF CUT (FIG. 27)
1.
Loosen the two clamping knobs.
2.
Slide the fence in or out relative to the cutter.
NOTE: Holding the fence at both ends while sliding
it will make it easier to move.
3.
Securely retighten the clamping knobs.
TO ADJUST THE FENCE FOR JOINTING
(FIG. 27)
1.
Loosen the two fence clamping knobs holding the
left lower fence to the upper fence.
2.
Slide the fence to the left until it is fully
disengaged from the upper fence.
3.
Rotate the lower fence 180° and reassemble
to the upper fence, making sure the weld nuts
engage the slot in the lower fence and the tab
on the upper fence engages the slot on the
lower fence.
4.
While pressing the lower fence against the upper
fence, retighten the two fence clamping knobs.
TOOLS REQUIRED:
• Router collet wrench (included with router)
Because of the large variation of routers and router bits,
certain router bits may not always operate in the
desired manner with this router table.
Install and position the router bit in the router collet as
described in the router owner's manual.
Router Table Operation
SETTING UP THE FENCE
TO ADJUST THE ROUTER BIT HEIGHT
To adjust the depth of cut into the workpiece, consult
your router owner's manual.
upside down (such as on a router table), will drop
or fall out of the router base when the base clamp
is loosened to adjust the height or depth of cut.
Be sure the router is supported from below when
adjusting or whenever the base clamp is loosened.
FIG. 27
INSTALLING THE ROUTER BIT
entire unit (table with router installed) is placed on
and secured to a solid, flat, level surface and will
not tip.
24
Some routers, when positioned
FENCE CLAMPING KNOBS USED TO
ADJUST FENCE OPENING FOR
ROUTER BIT CLEARANCE
ROUTER TABLE SHOWN FROM BACK
Before operating, make sure the
FENCE CLAMPING KNOBS USED
TO ADJUST FENCE OPENING
FOR ROUTER BIT CLEARANCE
AND FOR JOINTING
CLAMPING KNOBS
USED TO ADJUST
DEPTH OF CUT
LEFT
LOWER
FENCE
Publicidad
