NODOR NorCook IH N6404 BK Manual De Instrucciones página 24

Functionality Slider TC
The touch control comprises touch displays that light up according to the following criteria:
· The keys of the functions available light up with low intensity.
· The key selected lights up with a higher intensity.
· The keys for functions that are not available remain unlit.
Slider (2): sensor technology of Slider TC allows an adjustment of the cooking levels (1 – 9) as the timer value
(1-99) by touching and pulling the finger over the designated area. Pulling to the right is increasing and to
the left is decreasing accordant value. Moreover, a direct selection of the designated value is also possible
on the slider area.
Nsense: Automatic cookware detection
Place a suitable piece of cookware on the hob.
The control automatically detects the presence / absence of a pan in every cooking zone. If a pan is detected,
display (10) of the corresponding zone will constantly read "0" until the required power level is selected.
Select the power level by sliding your finger over the control (2).
If the touch control is switched on, the cooking zone can be selected by pressing the button (10) of the co-
rresponding zone.
If you lift the cookware, the display (10) will show the symbol
cookware back after this time, the control will switch off.
If you place a piece of cookware that is too small or made of unsuitable material, the slider (2) and the display
(10) will not be activated.
Power management
This function is designed to avoid overloading the system with excessive power demand. If high outputs have
been selected for two pieces of cookware placed close to one another, the output of the piece of cookware
that was placed first will automatically be reduced if necessary. The designated display (5) will flash for 3 se-
conds before switching to a lower power. During these 3 seconds you can select a lower power for the other
piece of cookware if you wish. Otherwise, the power supply for the first piece of cookware will automatically
be reduced.
Nheat: Residual heat indicator
This safety function serves to identify areas of the glass that have a temperature above 60°C, which could
cause burns if touched.
The display (10) designated to the hot area displays the letter "H" whether the hob is switched on or off. If
cooking is in progress, then the display (10) designated to the cookware will only show the selected power
level.
Nboost: Booster function
The Booster function allows the power supplied to the cookware to be increased above its nominal value
for 5 minutes. Once this time has passed, the power will automatically decrease to level 9. This function is
designed to heat or boil large amounts of water in a short time.
Due to its high power, the Booster function should only be used when cooking with water. Oil or fat could
cause burns.
If the touch control is switched on, the cooking zone can be selected by pressing the button (10) of the co-
rresponding zone.
The Booster function can be selected by pressing the far right of the sliding control (2).
To cancel this function, select any other power level on the slider (2).
60819760.31.08.2020.indd 24 60819760.31.08.2020.indd 24
for 10 minutes. If you do not put the
8/10/20 10:34 8/10/20 10:34