Skymsen AMP-400 Manual De Instrucciones página 6

6. MAINTENANCE
Maintenance must be considered a set of procedures
with the purpose to keep the equipment best operating
conditions, therefore increasing the equipment life and
safety.
* Cleaning – check item 3,4 Cleaning
* Wiring - Check all wires regarding deteriorate conditions as
well as all electric contacts (terminals) regarding tightening
and corrosion.
*Contacts – ON/OFF switch, emergency button, reset
button, electronic circuits etc, check the equipment in order
to assure that all components are correctly working and the
equipment operation is normal.
* Installation – make sure the installation followed item 2.1
instructions
* 1 – Each month check :
- Check the electrical installation
- Measure the voltage at the socket
- Measure the working current and match it with the
nominal current
- Check the tightening of all electric terminals to avoid bad
contacts
- Check electric motor shaft clearance
- Check the wiring for overeating, insulation failures and
mechanical damages.
*2 Each three month checks
- Check electrical components such as ON/OFF switch,
emergency button, reset button, electronic electric circuits,
overeating, insulation failings, or mechanical damages
- Check bearings clearances
- Check retainers, O'rings, V'rings and other seals
Use Your QR Code Reader to access
more information regarding safety and
maintenance.
7. PROBLEM SOLVING
This equipment has been designed to operate with the need
of minimum maintenance but the natural wearing caused by
longer use of the equipment may occasionally cause some
malfunctions.
If such problem occurs with your Blender refer to Table
02 in which the most common situations are listed with
recommended solutions.
6