Descargar Imprimir esta página

Parkside PTPS 1100 A1 Traduccion Del Manual De Instrucciones Originale página 24

Bomba sumergible para aguas sucias

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 106
GB
IE
Set the length of the
fl oat switch cable
1. Hold the fl oat switch height adjustment
(2) in position.
Float switch cable (12) set too short
2. Pull the fl oat switch cable at the fl oat
switch (3) to extend.
Float switch cable (12) set too long
3. Pull on the fl oat switch cable at a point
before the fl oat switch height adjust-
ment (2).
Manual mode
In manual mode, the pump does not switch
off automatically, as the fl oat switch (
3) is bypassed.
Position the fl oat switch (3) vertical-
ly upward in the fl oat switch height
adjustment (2).
Monitor the pump constantly when
in manual mode. Switch the pump
off immediately (disconnect from the
mains) if no more water is being
pumped. There is a risk of damage
if the pump runs dry.
Operational start-up
• Check that the pump is standing
fi rmly on the bottom of the shaft
or hung up safely.
• Place the pump on a brick and
not on a shaft fl oor, if applica-
ble. This prevents damage to the
pump if the shaft fl oor is soiled.
• Check whether the pressure line
has been attached correctly and
24
the unused pump outlet is fully
closed.
• Avoid that the pump runs dry.
Regularly check the function
of the fl oat switch. In case of
non-observance or if the pump
runs dry, guarantee and liability
claims are invalidated.
• Check that the electrical connec-
tion is 230 V~ 50 Hz
• Check the proper status of the
electrical plug socket and make
sure that the plug socket is suf-
fi ciently fused (at least 6 A, RCD
switch). Insert the pump plug into
the plug socket and the pump is
ready for operation.
• Make sure that moisture or water
never come in contact with the
mains connection. There is a risk
of electrocution.
Cleaning/Maintenance/
Storage
Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.
This will prevent damage to the
equipment and any resulting per-
sonal injury.
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.

Publicidad

loading

Este manual también es adecuado para:

373831 2104