sunjoe SPX2688-MAX Manual Del Operador página 11

NOTE: The GFCI may need to be reset when first plugged into
the electric outlet. Press the "Reset" button until the power
light indicator on the GFCI illuminates when plugged in.
5. Turn the water supply tap on completely.
6. Release the safety lock, then press the trigger for a few
seconds until the water flow is steady. Operating the
pressure washer in this manner will allow air to escape and
discharge residual pressure in the hose (Figs. 13 – 14).
Fig. 13
Fig. 14
7. Turn the ON/OFF switch to the ON (I) position to start the
pressure washer (Fig. 15).
Fig. 15
ON/OFF switch
8. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Using Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
The nozzle patterns are 40° (for gentle cleaning), 15° (for tough
jobs), and 0° (for spot cleaning or hard-to-reach areas) .
m
CAUTION!
safety lock on the trigger handle.
m
WARNING!
subject to misuse. The jet must not be directed at persons, pets,
live electrical equipment, or the appliance itself.
Safety lock
This electric pressure washer is equipped with three (3) Quick-
Connect nozzles that easily snap onto the Quick-Connect collar
of the spray wand.
To connect a nozzle to the spray wand:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle.
3. Pull back the brass Quick-Connect collar and insert the
desired nozzle into the collar. Release the collar and the
nozzle will click into place (Fig. 16).
Fig. 16
Spray wand quick-
connect collar
Nozzle
Trigger
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle.
3. Remove the nozzle by disconnecting it while pulling back
the brass Quick-Connect collar.
m
WARNING!
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
11
NEVER change nozzles without locking the
High-pressure jets can be dangerous if
Do not make changes to the nozzle while