Stihl KB-KM Manual De Instrucciones página 7

WARNING
When transporting it in a vehicle,
properly secure it to prevent turnover,
fuel spillage and damage to the unit.
Before Starting
WARNING
Always check your power tool for proper
condition and operation before starting.
Never attempt to modify the controls or
safety devices.
WARNING
Never use a power tool that is damaged
or not properly maintained.
WARNING
Do not attach any sweeping attachment
to a unit without proper installation of all
required parts. Failure to use the proper
parts may cause the working tool to fly
off and seriously injure the operator or
bystanders.
KB-KM, KW-KM
Position the gearbox so that the axle for
sweeping and cleaning attachments is
above the drive shaft.
WARNING
The sweeping attachment must be
properly tightened and in safe operating
condition. Inspect for loose parts (hitch
pins, screws, etc.) and for damaged
parts. Replace damaged parts before
using the power tool.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
Keep the deflector adjusted properly at
all times (see chapter on "Assembling
the Unit" of your instruction manual).
Adjust carrying harness and hand grip to
suit your size before starting work. The
machine should be properly balanced as
specified in your instruction manual for
proper control and less fatigue in
operation. To be better prepared in case
of an emergency, practice releasing the
unit from the harness as quickly as
possible.
Starting
WARNING
Start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only.
For specific starting instructions, see the
appropriate section of your
KombiEngine and KombiTool manuals.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
If you start the engine the working tool
will rotate when the engine starts – this
may set the sweeping attachment in
motion back towards the operator.
WARNING
To reduce the risk of injury from loss of
control, be absolutely sure that the
working tool is clear of you and all other
obstructions and objects, because when
the engine starts at starting-throttle,
engine speed will be fast enough for the
clutch to engage and move the working
tool.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
and allow the engine to slow down to
idle.
With the engine running only at idle,
attach the power tool to the spring hook
of your harness if you are using one (see
appropriate chapter of this manual).
WARNING
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
See also the safety precautions on
Starting in the instruction manual of the
KombiEngine.
English
5