cecotec ENERGYSILENCE 4260 FULL SUNLIGHT Manual De Instrucciones página 45

3. PRODUCT ASSEMBLY
General assembly instructions
If you hang the fan on a hook, the latter must withstand at least 100 kg.
-
- To prevent personal injury and damage, make sure that the location where the appliance is
going to be installed allows a 2.3-metre clearance from the blades to the floor and a 76-cm
clearance from the blades to any wall or object. Fig. 3
- Make sure that the building structure can hold the full weight of the fan.
This fan can be installed on a normal or vaulted ceiling with a downrod. The hanging length
-
can be extended by using a longer downrod.
Assembly according to the type of ceiling. (Fig. 4):
1. Normal ceilings
2. Sloped ceilings (might require a longer downrod, not supplied by Cecotec)
3. Wooden ceiling. Fig. 5
4. Concrete ceiling. Fig. 6.
Fig. 7 key:
1. Black and Blue
2. White
3. Earth
4. Phase (Brown/Black)
5. Neutral (Blue)
6. Earth
To assemble this ceiling fan, follow the steps below (Fig. 3-12):
1. Remove the lower and upper pins from the downrod and release the hanging ball at the
top of the rod.
2. Pass the wiring from the main body through the downrod.
3. Attach the downrod to the main body by inserting the pin through the downrod and the
main-body attachment. Tighten the screws provided on the main-body attachment to
properly secure the downrod.
4. Remove the 4 screws that fix the upper canopy and the installation bracket. Insert the
upper canopy through the downrod.
5. Insert the pin through the pin holes located on the upper end of the downrod. Once
inserted, slide the hanging ball upward to the upper end of the downrod and fix it with one
of the screws provided. Fig. 8-9
6. Make sure the pin fits in the slots located inside the hanging ball before screwing it.
7. Mark the centre of the installation bracket and use both self-tapping screws provided
with their corresponding washers and pressure washers to fix the installation bracket to
a wooden ceiling.
ENGLISH
ENERGYSILENCE 4260 FULL
45