Publicidad
Idiomas disponibles
Idiomas disponibles
-
Use the speed buttons to select the air power level.
-
Press the power button to turn the appliance off.
Use the timer buttons to select the fan operating time. The fan will turn off once the
-
selected time has elapsed.
Press the light button to turn the fan's lamp on and off.
-
Winter Function
Press the Winter/Summer button. The fan will make air flow from the bottom upwards,
bringing cold air to the top of the room.
Summer Function
Press the Winter/Summer button. The fan will make air flow from the top downwards, bringing
cold air to the bottom of the room.
Warning
Invert the spinning direction of the fan while in operation. Hold down the button for approx.
3 seconds: the appliance will beep, and the blades will start slowing down until they stop
spinning. After a few seconds, they will start spinning again in the opposite direction.
Pairing the remote control with the fan
Press the off button for 5 seconds until you hear a beep. Then, press the low-speed button.
Natural breeze
Activate this mode by pressing the corresponding button on the remote control. The fan will
run at different power levels in a cycle, producing a feeling of fresh air.
Warnings
The remote control operates through RF Wireless digital transmission technology. If both
-
the fan and the lamp are equipped with a switch, turn on the fan at top speed and turn the
light on before using the remote control.
If the fan or the light cannot be controlled through the remote control, check if the batteries
-
in the remote control are in good conditions and if they make good contact, that the positive
and negative electrodes are in the correct position, and if the batteries are charged.
If the fan or the light cannot be controlled through the remote control, check if there are
-
other remote-controlled appliances in the same area and check if the transmitter buttons
are pressed. Appliances with similar remote-control systems may cause interference. This
does not include infrared remote controls.
-
Pay attention to the appliance voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
If the remote control is not going to be used for a long time, remove the batteries.
-
ENGLISH
ENERGYSILENCE 4260 FULL
47
Publicidad
