cecotec ENERGYSILENCE AERO 5200 LIGHT DESIGN Manual De Instrucciones página 46

ENGLISH
and negative electrodes are in the correct position, and if the batteries are charged.
- If the fan or the light cannot be controlled through the remote control, check if there are
other remote-controlled appliances in the same area and check if the transmitter buttons
are pressed. Appliances with similar remote-control systems may cause interference. This
does not include infrared remote controls.
- Pay attention to the appliance voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
- If the remote control is not going to be used for a long time, remove the batteries.
Changing the remote-control battery
The remote control requires 2 x 1.5 V-3 AAA batteries.
1. Open the battery compartment.
2. Insert the batteries into the battery compartment observing the polarity.
3. Close the compartment.
5. CLEANING AND MAINTENANCE
- Make sure to disconnect the fan before cleaning it.
- Do not immerse any of the parts of the appliance in water or splash them with any other
liquid.
- Do not use solvents or any other chemical products for cleaning.
- Use a soft, damp cloth to clean the surface of the device.
6. TECHNICAL SPECIFICATIONS
Product reference: 08539
Product: EnergySilence Aero 5200 Light Design
Voltage: 220 - 240 V
Frequency: 50 / 60 Hz
Power: 21W DC - Max 50
LED: 50 W
46 ENERGYSILENCE AERO 5200 LIGHT DESIGN