Toro Ultra 51594 Manual Del Operador página 3

Setup
1
Assembling the Blower
Parts needed for this procedure:
Install the blower tube and then the inlet cover onto the blower housing.
NOTICE! You must install the blower tube before installing the
inlet cover because the inlet cover hooks onto the blower tube.
The blower will not run unless the bottom inlet cover is locked
in place.
2
Converting from Blower to Vacuum
Parts needed for this procedure:
WARNING
The impeller rotates for a few seconds after you turn off the
blower and can cut or injure fingers.
Do not remove the bottom inlet cover when the motor is running
or when the unit is plugged into a power outlet.
1. Remove the inlet cover and the blower tube from the blower
housing.
2. Install the vacuum tube onto the blower housing and connect the
lower vacuum tube to the upper tube, securing it with the supplied
fastener.
NOTICE! The vacuum will not run unless the vacuum tube
is locked in place.
Note: You may need to push the connector firmly to ensure that
it seats all the way into the vacuum tube.
3