Dreame Z30 Manual De Usuario página 16

Battery Status Display
EN
1. Battery Status Indicator
Blinking white
Solid white
Off
Charging
Fully charged
Charging
Standby Mode
Fig. D-2
2. Display Screen
The number on the display screen
represents the current battery level in a
percentage during charging. When the
number becomes 100, the battery is fully
charged.
Fig. D-3
How to Use
Display Screen
1. Dirty Level Indicator
The color changes with the amount of
dust in real time (only in Auto Mode).
2. Particulate Matter Amount Indicator
3. Suction Level
Eco
Auto
Turbo
4. Suction Level Switch
Press briefly to switch between eco,
auto and turbo mode.
5. Particulate Matter Types
＞ 10μm (eg. pollen)
＞ 50μm (eg. hair)
＞ 200μm (eg. dust)
＞ 500μm (eg. mite)
6. Battery Level Percentage
When the display screen shows "LO", it
indicates that the battery level is lower
than 10%.
7. Power Button
Press briefly to turn on/off
Fig. E-1
4
Settings
In the standby state, press and hold the
suction level switch
enter the setting interface. Briefly press the
switch button to select an option, and
press and hold for 3 seconds to confirm.
Reset Filter
Press and hold the suction level switch
3 seconds to select resetting filter and the
filter will automatically complete the reset.
Exit
Press the power button
setting interface to return to the main interface
directly, or select
3 seconds to return to the main interface.
Fig. E-2
Note:
• If there is no operation for more than 15
seconds, the screen will turn off, and it will
return to the main interface when lit up
again.
• In a high altitude area, it is recommended
to switch to high-altitude mode before use
to avoid abnormal use (press and hold the
suction level switch for 3 seconds until the
setting is displayed, then press and hold
the power button for 3 seconds to enter/
exit the high altitude mode).
• If the vacuum is not working properly, the
screen display will show an error message.
Please refer to the troubleshooting table to
find your solution.
Starting Cleaning
Press the power button
After the vacuuming is completed, press
the button and the amount of various
particle matters vacuumed will show on the
screen.
Press the button to switch levels between
auto, eco and turbo and the corresponding
icon will show on the screen.
Note:
• When any cleaning mode stops running,
the vacuum cleaner will default to auto
mode when it is started again. Factory
default setting is the auto mode.
for 3 seconds to
when it is in the
, then press and hold
to start operating.
for
for